Sensormatic View Manager 96 Console Guia de Instalação descarregar pdf (Página 162)

162 Sun Java System RFID Software 3.0 Administration Guide • February 2006

■ For ISO 18000-6B, Intermec Intellitag, Philips I-CODE HSL, the value is

IS186B.

■ For Alien EPC, the value is EPC1.

■ For EM 4022, EM4222 the value is STG.

■ For EPC0, the value is EPC0.

■ readerepcANTn–Specifies the EPC value associated with the ANT1, ANT2,

ANT3, and ANT4 antennae of the reader, where the variable n equals the

number of the antenna. This property overrides the value specified by

readerepc for this particular antenna. The readerepc property applies to the

entire system as long as an EPC has not been specified for a particular antenna.

The readerepcANTn property is useful for specifying that the events from two or

more antennae from a single reader be handled by two or more separate

processing chains. See also readerepc.

Note – It is not necessary to set the antenna property to enable the use of the

various antennae. Setting the EPC identifier for the antenna instructs the RFID Event

Manager to discriminate between the antennae if they are enabled. Enabling a

specific antenna is done through the use of the antennaSequence property.

■ cycles – Specifies the Antenna Inventory Round Operations. The SAMSys

reader enables the Multiplexer Configuration Word (MCW) register to be set to

specify the number of inventory operations per round. This property defines the

number of inventory operations performed on each antenna before moving to the

next antenna in the antenna sequence. See the SAMSys Comprehensive Heuristic

Unified Messaging Protocol in the SAMSys documentation for more detailed

information.

■ antennanPower – Specifies the desired power level. The SAMSys reader has 48

power settings. The lowest setting is 60, translating to 12 dBm and 16 mW. 02

corresponds to 34.7 dBm 2.95 W.

■ regulatoryParty – Sets the Transmit Power Configuration (TPC) register

within the SAMSys reader. Setting the value of this property to FCC sets the

reader for FCC operation. Setting the value to ETSI sets the reader to ETSI

operation with frequency hopping. Leaving the property unset leaves the reader

60, 5e, 5c, 5a, 58, 56, 54, 52, 50,

4e, 4c, 4a, 48, 46, 44, 42, 40,

3e, 3c, 3a, 38, 36, 34, 32, 30,

2e, 2c, 2a, 28, 26, 24, 22, 20,

1e, 1c, 1a, 18, 16, 14, 12, 10,

0e, 0c, oa, 08, 06, 04, 02

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 191 192

Sem comentários

Sensormatic View Manager 96 Console Guia de Instalação Página 162