Sensormatic VM96 INS Manual do Operador descarregar pdf (Página 99)

TOUCH TRACKER Utilities 6-5

address for each additional TOUCH TRACKER. The following procedure

describes how to set up a new T

OUCH TRACKER link address or change an

existing link address.

1. At the LCD Utility Mode prompt, press 2 on the T

OUCH TRACKER

whose address you want to assign or change.

The LCD displays the following message:

2. On the T

OUCH TRACKER, press the number—between 1 and 8—that

corresponds to the address you want to assign to this T

OUCH TRACKER.

Typically, you would want to assign these link addresses from highest to

lowest. For example, if you have four T

OUCH TRACKERs, you would

plug them in one at a time, setting the link address for T

OUCH TRACKER

4 first and working your way down to T

OUCH TRACKER 1.

The LCD displays the following message:

If the address you assigned is available, the LCD displays this message:

Otherwise, the LCD will indicate that the address is unavailable.

If the “Checking Address Availability” message appears on the

LCD for longer than one minute, there is probably a communication

error. Unplug the T

OUCH TRACKER, then plug it back in to reset it.

Verify that VM96 is operating properly before you try to change the

OUCH TRACKER’s address again. If problems persist, try changing the

OUCH TRACKER address with the system turned off.

3. On the T

OUCH TRACKER, press Clear Entry to return to the Utility

Mode prompt.

Link Address x

New Addr(1-8)?

Checking Address

Availability

Address Granted

Press Clear

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 121 122

Sem comentários

Sensormatic VM96 INS Manual do Operador Página 99