Sensormatic SpeedDome Ultra IV Manual do Operador descarregar pdf (Página 36)

Alarms, Areas and Home Settings 4-9

Programming Area Boundaries

Areas are programmed start and end points of a camera's field of view. Each area is a part of

a circular viewing area that extends around the dome. The areas can be different sizes, as

shown in the following illustration:

Area 1

Area 2

Area 3

Area 4

Area 5

Area 6

Area 8

Start Area 1/

End Area 8

Area 7

Figure 4-5: An example of areas

The end point of one area is the starting point for the next area. The end point of the last area

cannot go past the starting point of the first area. If your controller supports areas, these are

separate from the areas you can program with the dome. You should not use both the

controller and the configuration utility to define areas.

The zoom setting also affects how large areas appear. When you zoom in to an area, the area

may appear to be small. When you pan the dome, area boundaries may appear to be close.

However, if you zoom out, the area appears to be larger. When you pan the dome, the area

boundaries appear further apart. With this in mind, it will be easier to establish area

boundaries if the zoom factor is small than if the zoom factor is large.

When Program Area Boundaries is selected from the Alarms/Areas/Home screen, the

following appears:

Black circle

represents

the dome.

When zoomed in,

areas appear to be

smaller than when

zoomed out.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 75 76

Sem comentários

Sensormatic SpeedDome Ultra IV Manual do Operador Página 36